can someone help me with my project 🙁 theses are the instruction.

Insert the Arduino Uno board on the breadboard, with its pins aligned with the breadboard's power rails. Connect the cathode (short leg) of the first LED to the ground rail of the breadboard using a 220 ohm resistor. Connect the anode (long leg) of the first LED to pin 13 of the Arduino Uno board using a jumper wire. Connect the cathode (short leg) of the second LED to the ground rail of the breadboard using a 220 ohm resistor. Connect the anode (long leg) of the second LED to pin 12 of the Arduino Uno board using a jumper wire. Connect one end of the push button to pin 2 of the Arduino Uno board, and the other end to the ground rail of the breadboard using a jumper wire. Connect the photoresistor to the breadboard, with one leg connected to the power rail of the breadboard and the other leg connected to the ground rail of the breadboard. Connect the middle pin of the photoresistor to pin A0 of the Arduino Uno board using a jumper wire. Connect another 220 ohm resistor from pin 2 of the Arduino Uno board to the power rail of the breadboard.

anyonee??

> Insert the Arduino Uno on the breadboard that isn't possible

Maybe

Here's a diagram of what you need to build

Just a question is the red the photoresistor?