hammeraster
Urgent???
This isn’t the typical I need help topic. If I can’t fix this I can’t use my raspberry pi. I’m not willing to reflash my micro se card a million times until it decides it want to work with me. So I was using PiKiss to install Vulkan Drivers on the Raspberry Pi 5. One small issue the two times I had to reflash my sd card and redo the process, it stopped the first time a random amount of time during either downloading or installing the drivers. The second time is when it would work, the issue is, the second time I rebooted then tried to install then it installed without issues, or so it seemed. I downloaded some Vulkan demos to test and they worked flawlessly. Cool right? WRONG 1. Some open/webgl websites that I tried had HORRIBLE fps. Just as a test I pulled screenshots from a prior flash of the sd card without all this Vulkan nonsense. 60fps on the website! After both of these 2nd Vulkan download attempts I would average 15-23fps. Something’s wrong!! I reboot and low and behold NO MORE GUI! 😑🤬🤬 Now I’m just mad. I knew the GUI was gone because I waited 15 minutes for it but the text cursor you usually see for a split second on boot was it here flashing. So I hold alt+F2 so I can use text mode. And when I tried to run the Vulkan program that ran not even 5 minutes ago shows the following image. Please help I’ve been troubleshooting for hours and now I’m actually getting to that point where tears are about to start rolling because I’ve wasted my entire day on this with no success!
TLDR: how do I get VULKAN drivers installed with zero error?